Install stone tile wall

Slate tiles can be purchased in an array of sizes and varying colors.

Safeguard and boost the walls behind your timber stove by installing slate tile. The tile not merely safeguards the walls from soot in addition to occasional stray ember but in addition adds a definite appearance that will enhance your house's decoration. Be aware, however, that a tile finish alone doesn't make the wall non-combustible. Follow all needs of the neighborhood building signal also set up instructions through the kitchen stove manufacturer. Placing a wood stove also near to a combustible wall surface can cause a significant fire threat.

Draw a grid in the wall surface behind the stove making use of a pen and 4-foot level. Since each square inside grid represents one tile, it ought to be adequate to allow for the tile and surrounding grout bones.

Blend a suitable number of thinset adhesive in a 5-gallon container with a spade exercise and blending paddle. Stick to the manufacturer’s directions for mixing this product.

Beginning with the initial row, use the thinset toward wall surface making use of a notch trowel. Keep a 45-degree perspective on the trowel whenever dispersing the adhesive to make a smooth, even and consistent layer.

Measure and cut the slate tile, whenever appropriate, making use of a wet saw or angle grinder with connected diamond knife.

Work with little parts at a time, anyone to three squares, that enable you the full time to position and align the tiles in their respective opportunities ahead of the adhesive begins to set. Hit initial tile into location and continue establishing the rest of the tiles through to the first row is total.

Utilize thinset adhesive to the second row in the grid, above the previously put in tiles.

Press the initial tile of the second row into spot. Utilize appropriately-sized tile spacers to support the next row tiles and also to give you the desired size of grout joint. Continue this procedure regarding the continuing to be rows until the wall is full.

Enable the tile to set overnight before grouting the bones.

Blend a suitable number of grout, relating to manufacturer’s guidelines, in a clean container making use of a margin trowel.

Distribute the grout on the tile and work the material to the bones making use of a grout float.

Let the grout to haze, or set up for around 20 minutes. Pull extra grout by cleaning the outer lining with a damp sponge in circular motions.

Permit the area to dry and wipe clean with a clear, wet sponge.

Issues Will Need

Pencil
4-foot degree
Thinset adhesive
Buckets
Spade exercise
Mixing paddle
Notch trowel
Tile spacers
Damp saw or position grinder with affixed diamond knife
Protection goggles
Respirator
Grout
Margin trowel
Grout float
Sponge

Tips

Its much easier to remove excess thinset from grout joints with a margin trowel before it dries.
When grouting, rinse the sponge over repeatedly in clean liquid between wipes.