Stone veneer Tile fireplace

Inside movie, This Old home senior technical editor shows utilizing rock veneer to obtain the cozy feel of a masonry fireplace without breaking the spending plan

Shown: Filedledge stone in Andante; Eldorado Rock.

1. Protect the fireplace surround with builder's felt. Work through the bottom up and overlap pieces by 2 inches.

2. Nail material lath within the felt. Place it and so the glasses face up to get the mortar.

3. Cover the wall surface with ½ inch of veneer mortar. After 20 moments, brush the mortar with a notched trowel. Allow the mortar dry immediately.

4. Create a design for the rocks on a fabric, staggering shapes and sizes. Keep finger-width bones between stones.

5. Cut spot pieces by scoring the cut line with a grinder after that hitting them with a stone hammer.

6. Install the first pieces in the header above the hearth opening. Then relocate to the sides of the fireplace orifice, the sides associated with surround, and lastly the area. Work from the top down.

7. Spray the back of each stone with water, after that butter it with mortar. Draw a furrow in the mortar because of the tip of the trowel.

8. Hit the piece positioned and wiggle it to seal it into scrape coating.

9. While using the pieces positioned, clean the joints with a striking device and a whisk broom. Allow the mortar cure instantaneously.

10. Grout the bones with veneer mortar squeezed through a bag. Let the grout cure for an hour or so, then contour the bones and clean all of them for an all-natural appearance.