Faux stone tiles for fireplace

August 16, 2017
Class and character added to a
Create a Faux rock Accent Wall

Additional materials you’ll need

Besides the veneer stone, you’ll need 1/2-in.-thick cement board, 2-1/4-in. cement-board screws, polymer-modified thin-set glue, mesh cement board tape and tile shims. You’ll find all those services and products home centers and tile shops. Cement board is readily available in 32 x 60-in. sheets. Buy sufficient cement board to pay for the wall, bearing in mind you may have to cut the center sheets right down to 48 in. very long therefore the stops land on studs. You’ll need about one 50-lb. bag of thinset for each 70 sq. ft. of wall location, and another bundle of screws for almost any 40 sq. ft. of wall. You’ll utilize the tile shims to amount the initial row of rock.

Score the cement boardYou could also need electrical package extensions, cable connections and short lengths of line to remount outlets and switches. You’ll find these when you look at the electrical department at equipment shops and house centers.

Choices for cutting the rock

We used a wet-cutting tile saw to cut the stone as this could be the quickest and minimum dusty technique. You can purchase a tile saw just like the one shown right here for about $300, you can also rent one for approximately $50 a day. If you can cut outdoors and don’t want to rent or buy a tile saw, you could use a circular saw with a diamond blade, or a grinder with a diamond blade, to cut the stone. But be ready for a dusty, noisy work.

Break the board1: starting out: area planning

Setting up the stone is certainly going lots smoother and easier if you take sometime to get ready the area. Start by going everything out of the space. Areas of this job can be dusty, and also you don’t wish to have to clean everything later on. That which you can’t move out, address with sheets of painter’s synthetic. Protect carpeted floor coverings with fall cloths. Protect hardwood and tile flooring with a layer of cardboard or slim hardboard before covering these with fall cloths.

Pry from the baseboard trim on the wall surface in which the stone goes, as well as on adjacent wall space. If you’ll be reinstalling the same trim, pull the fingernails through the back of this trim with an-end cutter or a locking pliers. When you have seat rail or top molding, you’ll must eliminate these, too.

Screw cement boards toward studsTo save a while and energy, we’re showing how-to install the newest cement board on top of the prevailing drywall. But if you need to include outlets or sconce lights or do various other extensive wiring, it could be easier to eliminate all of the drywall from your wall.

If you opt to leave the drywall positioned, level the biggest market of each stud with a chalk line therefore you’ll know the best place to drive the cement-board screws. Very first utilize a stud finder or some other solution to find the middle of each stud at the top and bottom associated with the wall surface. Then stretch a chalk line between the marks and snap the lines.

Cut stops with a tile saw slice the very first line of stone Notch around outlets Install the box expansion
Source: www.familyhandyman.com
Share this Post